-40%

mAT-125E HF Automatic Antenna Tuner Magnetic Latching Relay YAESU ICOM KENWOOD

$ 84.67

Availability: 100 in stock
  • EAN: Does not apply
  • Type: 432523254
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Compatible Brand: Universal
  • Condition: New
  • Item must be returned within: 30 Days
  • Model: rw34
  • Brand: Unbranded
  • Return shipping will be paid by: Seller
  • All returns accepted: Returns Accepted
  • UPC: Does not apply
  • MPN: Does not apply

    Description

    Welcome to my shop
    Product Overview
    mAT-125E HF Automatic Antenna Tuner Magnetic Latching Relay YAESU ICOM KENWOOD
    Detail
    mAT-125E
    HF-SSB General Automatic Antenna Tuner
    INTRODUCTION
    The mAT-125E is an automatic tuner intended for use with HF transceivers. The mAT-125E can
    work within the range of 3MHz to 54MHz.
    The mAT-125E provides automatic antenna tuning across the entire HF spectrum plus 6 meters,
    at power levels up to 120 watts. It will tune dipoles, verticals, Yagis, or virtually any coax-fed
    antenna. It will match an amazing range of antennas and impedances, far greater than some
    other tuners you may have considered, including the built-in tuners on many radios.
    The mAT-125E also features advanced memory tuning, providing 16000 memory locations;
    when tuning near a previously used frequency it will recall the settings for nearly instant tuning.
    It learns your favorite frequencies and bands as you use it. You can also start a tuning cycle
    manually whenever necessary.
    The mAT-125E has 16,000 frequency memories. When tuning on or near a previously tuned
    frequency, the mAT-125E uses “Memory Tune” to recall the previous tuning parameters in a
    fraction of a second. If no memorized settings are available, the tuner runs a full tuning cycle,
    storing the parameters for memory recall on subsequent tuning cycles on that frequency. In this
    manner, the mAT-125E “learns” as it is used, adapting to the bands and frequencies as it goes.
    Two 18650 lithium batteries installed inside tuner to provide power for the tuner. Tuner is
    charged, can only be used with prescribed charger, the charger has the highest output voltage of
    8.4VDC. mAT-125E uses little power while tuning, and essentially zero power when in standby,
    when the equipment is full of electricity, it can work for a long time. These 18650 lithium
    batteries do not have a protective circuit, and the protection function is completed by tuner.
    SPECIFICATIONS
    - 0.1 to 120 watts SSB and CW peak power, 30 watts on PSK and digital modes, and 100 watts
    on 6 meters.
    - Latching relays for ultra-low power operation.
    - 16,000 memories for instantaneous frequency and band changing.
    - Works with most radios that output power can be reduced to less than 10 watts
    - Tuning time: 0.1 to 5 seconds full tune, 0.1 seconds memory tune.
    - 1.8 to 54.0 MHz coverage. Built-in frequency sensor.
    - Tunes 5 to 1500 ohm loads.
    - For dipoles, verticals, Vees, beams, long wire or any coax-fed antenna.
    - Includes a lithium battery charger.
    - Dimensions: 20cm x 13cm x 4cm (L x W x H). Weight: 0.8Kg.
    NOTE: Before the first use or after the battery is replaced, the tuner must be charged by the
    charger to activate the internal protection circuit before it can be used normally.
    SPECIFICATIONS
    - 0.1 to 120 watts SSB and CW peak power, 30 watts on PSK and digital modes, and 100 watts
    on 6 meters.
    - Latching relays for ultra-low power operation.
    - 16,000 memories for instantaneous frequency and band changing.
    - Works with most radios that output power can be reduced to less than 10 watts
    - Tuning time: 0.1 to 5 seconds full tune, 0.1 seconds memory tune.
    - 1.8 to 54.0 MHz coverage. Built-in frequency sensor.
    - Tunes 5 to 1500 ohm loads.
    - For dipoles, verticals, Vees, beams, long wire or any coax-fed antenna.
    - Includes a lithium battery charger.
    - Dimensions: 20cm x 13cm x 4cm (L x W x H). Weight: 0.8Kg.
    Shipping Policy
    Item Location
    Payment Mathord
    Returns Policy
    About Feedback
    Shipping Policy
    Item Location
    Payment Mathord
    1. PayPal payment accepted only.
    2. Items will be shipped to your eBay address. Please make sure it is correct.
    3. Payment must be received 4 days after auction ended.
    Returns Policy
    1. Customer satisfaction is our top goal. We believe our items are so outstanding. All products are quality checked. They are new and in good condition when shipped to our customers. We are convinced you will be happy with your Purchase.
    2. If product is defective or damage upon arrival, or wrong product shipped, please contact us immediately. Returns accepted within 14 days of delivery date and item must be in original new condition, not worn or altered in any way with attached tags & wrap. Otherwise deal is final. Return shipping must be paid by buyer.
    3. Please contact us first if you have any problems/questions/concerns. We will be happy to resolve any issues you may have in a cordial and friendly manner.
    4. We appreciate your Postive Feedback, and will do the same in return. DO NOT leave negative feedback without first communication with us. Please allow max 2 business days for us to response.
    About Feedback
    When you satisfied with our product and services please leave us positive feedback.
    If a problem occurs, contact us immediately with any email request. Just contact us using the " Ask the seller a question" link on eBay.